Our products

Energy efficinecy

Tips:

Certificates:

Duct blankets - glasswool

Thickness:	5cm
Dimensions:	110*1000cm
Covers:	Aluminum foil, glass cover or can be without cover
Scope of appliance:	External heat insulator for heating systems, cooling systems and air-conditioning. Inner heat and acoustic insulator for heating systems, cooling systems and air-conditioning

Our partners

Frequently asked questions

Insulating from the inside of the walls

One of the most common methods of thermal insulation

The room warms up quickly
The added layer for insulation actually reduces the space inside the room
The outside wall is cold and potentially wet, which increases the risk of condensation and freezing
The very application of the insulation on the inside is rather disturbing for the people living there
The exposure to the thermal (cold) bridges, results with condensation and can cause occurrence of moisture and mold.

Outside thermal facade

The outside wall is warm and dry, and it increases the thermal performances of the building
The thermal bridges are removed, the risk of forming thermal (cold) bridges, condensation, mold, etc. is reduced
It is an ease construction, and is applied on the outside in a short time
Financially is the most optimal thermal insulation

How to apply TERMOPOR-F?

1.The surface (brick, concrete etc.) at which the TERMOPOR-F is applied, have to be cleaned off any dust or bumps.
2.At the bottom of the wall the cornering outline is applied whose dimensions depend on the thickness of the TERMOPOR-F panels, for example, if you use panels with 50mm thickness than the cornering outline has to be with 53mm thickness.
3.The cornering outline on the wall is strengthened with standard screws and wall-rivets. Eventually as a replacement of the cornering outlines can be used a wood lath whose thickness is compatible with the thickness of the TERMOPOR-F panels, that are used for the thermal insulation.
4.Along the strengthened cornering lath on the wall the rabitz net is glued, whose bottom end after the application of the first panel is flipped over it. For the net application, special glue for polystyrene is used.
5.TERMOPOR-F 20kg/m³ panels are glued on the wall in that way the glue is equally spread on every corner of the panel and on several other places on the panel.
6.Every new row begins at the middle of the previous panel.
7.After the application of all the TERMOPOR-F panels is complete, the next step is the application of cornering PVC outlines on all the openings of the facade (doors, windows etc.)
8.On the glued TERMOPOR-F panels a layer of glue is applied and in it the rabitz net is pressed (5*5mm). The net is applied in that way that there is overlapping.
9.By adding just a little more glue you move on to the final refining of the surface, and after 24 hours, with a roller, all over the surface, a layer of the founding matter is applied.
10.Few hours after the application of the founding matter is applied has been done, you can start with the application of the top layer of the facade, for which we use a smoothing tool.

Thermal insulation of the floor

1.surface must be clean and smooth
2.the surface need to be cover with prajmer - a cold liquid (when there is a need for hydro insulation)
3.hydro insulation is placed (when there is a need for hydro insulation)
4.diletaciona bar is placed
5.Termopor® panels are placed with 30kg/m³ density (for perfect condition 2 layers are needed)
6.PE foil is placed for cover
7.concrete layer is being placed (it is advisable to use thin wire network)